FOM Industrie Mistral 26/26A



Variable angle end-milling machine.


  • End milling angle 45° Rh, 90°, 45° Lh and intermediate angles
  • Milling tool unit rotation speed 7000rpm
  • Max. milling tool size Ø 175mm
  • Manual feed of the milling tool unit (MISTRAL 26)
  • Automatic feed with rapid approach controlled by milling tool unit photocell (MISTRAL 26A)
  • Quick change milling tool unit
  • Milling tool unit balancing system
  • Milling units magazine with 9 slots
  • Spray mist blade lubrication system
  • Carriage stroke: X max= 350mm
  • Milling depth: Y max = 65.5mm
  • Maximum milling unit height: 125mm
  • Working capacity: see attached diagram
  • Patented system that allows profile positioning without the need for goniometries
  • Work table height 900mm
  • Non-abrasive work table that will not damage painted profiles
  • Set up for the extraction of chips and fumes
  • Integral safety guards around work table with opening lock
  • Double working pressure servo-controlled in low pressure
Power supply Mistral 26: 230/400V – 50Hz
Mistral 26: 275/480V – 60Hz
Mistral 26A: 230/400V – 50Hz
Mistral 26A: 275/480V – 60Hz
Total power installed 1.5kW
Air consumption  Mistral 26: 0.8 NL/cycle
 Mistral 26A 12 NL/cycle
Working pressure 7 bar


  • Cutter sleeve for milling units
  • Horizontal and vertical vices
  • 8-positions star-shaped length stop


  • Tungsten carbide sawblade (Ø on request)
  • Additional cutters sleeve (including closing spacers)
  • Minimum quantity lubrication (MQL) with pure oil
  • Removal of milled profile burr (MISTRAL 26A)
  • Additional charge for special voltage and cycle (Standard motor 230/400V three-phase 50Hz)
  • Additional charge for single-phase motor (Standard motor 230 single-phase 50Hz)
  • Additional charge for electrical version UL-CSA
  • Milling cutters
  • Soundproofing tunnel with automatic opening

Innovation specialists