FOM Industrie Matisse



Electropneumatic copy router with worktable rotation.



  • Spindle with dual rotation speed (6.000/11.800rpm)
  • Tool coupling ER 20
  • 2 vertical and 2 horizontal vices with safety valves
  • Double working pressure servo-controlled in low pressure
  • Manual rotation and pneumatic locking of the work table from 0 to 90°
  • Axis translation by indirect levers
  • Spray mist blade lubrication system
  • Possibility of working at angles
  • Rotation system preventing the loss of references during machining without losing the machine positioning
  • 2 copying templates located on the superior side of the machine in an ergonomic position and easily visible to the operator
  • 2 independent pneumatic tracers with double diameter selector Ø 5 and Ø 10 mm
  • Possibility of machining with copying jigs or mechanical stops
  • Highly rigid head unit due to four cemented and round guide-ways with movement along re-circulating ball bearings
  • Quick spindle stop for tool changing
  • Standard motor 230/400V three-phase 50Hz (special voltage three-phase 275/480V – 60 Hz – see optionals)
  • Air filter
  • Chip bin
Power supply 3F – 400V AC – 50Hz
Total power installed 0.55kW
Air consumption 3 NL/cycle
Working pressure 7 bar


  • Milling bit: 10mm. Ø – 10mm. Ø tang
  • Milling bit: 5mm Ø – 8mm Ø tang
  • Collet ER 20 for milling bit: Ø 10mm
  • Collet ER 20 for milling bit: Ø 8mm
  • Ring nut for milling bit locking
  • No. 2 templates
  • Vice jaw extension 1200mm (Rh and Lh)
  • Receding length stop (No. 6)
  • Compressed air gun with spiral hose (for machine cleaning)
  • Packing with heat-shrink plastic bag


  • Minimum quantity lubrication (MQL) with pure oil
  • Additional receding stop
  • Additional magnetic receding stop
  • Additional charge for special power supply with transformer
  • UL-CSA version plant
  • Variation for measurement unit in inches

Innovation specialists